![]() The more a technician practices fiber stripping, the more accurately they can do it efficiently in a one-slide maneuver for each stripped layer. There are professional stripping tools for optical fibers, which usually have dedicated stripping holes for the 250μm buffer, tight buffer layer and other additional coating layers and jackets. In order to fuse two fiber ends together they need to be stripped down to the cladding layer only the core and the cladding layer of the fiber can be fused together and the all buffer and coating layers must be removed. Strip the Fibers’ Buffer Coatings Accurately. In addition, the splicing area must be very clean and the fusion device must be place on a stable surface.Ģ. The protection sleeve is usually a solid tube that can be put on a fiber end but cannot be wrapped around the fiber after it has been spliced. Insert One Side of Fiber in the Splice Protective Sleeve.Īlthough, protecting the fusions splice part of the fiber is last step of this process, a technician should not forget to insert the heat shrink protection sleeve onto one side of the fibers. ![]() Main Steps of How to Do Fusion Splicing of Optical Fibers. Fusion Splicing require certain procedures like cleaving, aligning, heating and pushing the end faces of fibers together, and there special devices and tool that help technicians in performing proper fusion splicing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |